2wire HGV-2 Bridge mode?

[darth_rufio]

Can anyone teach me how to bridge mode this thing. I'm using the linksys adsl modem last time and today the singtel guy install the new mio box to my house so i need to take out my own modem. when i try to put it back, i can't connect to the internet. So now i'm thinking to use the 2wire as a bridge mode then connect it to my router. Hope someone here can help me.

[lsteo]

This may help What are some legitimate reasons to use bridge mode? (http://support.2wire.com/index.php?page=view&article=22&text=router&cat=&sort=)

[darth_rufio]

i try this but i still can't connect. i even try my linksys am300 plus my wrt54g but everytime i try to connect it says "ppp can't get ip" or something like that.

[tyh87]

u can try dmz the port u used to connect to your linksys router..

[xolatw]

can try this link to set your 2wire as bridge.... but my problem is that i can't connect to internet using the bridge alone.

[ch1234]

Can anyone tell me if I still can use the Mio voice if I set it to Bridge mode??

[tyh87]

1. Plug a lan cable from the 2wire lan port to your other router Wan port
2. Set your other router internet / Wan mode to dynamic IP
3. Go to your 2wire configuration page and look for the IP addess being assigned to your other router
4. Go to your 2Wire firewall configuration page and set that IP to DMZ mode
5. Go to your other router DNS configuration page. set the DNS to opendns (208.67.222.222 or 208.67.220.220) (The DNS does not get forwarded correctly)

You should able to use mio voice as usual. The bridge mode does not allow mio voice to be working normally as far as i know.

[tidus792]

MIO voice doesn't work in bridge mode.
Rather good knowledge of configuration is needed if you want to get it working in bridge mode.
Search for the thread on mio voice without mio box. If you understand it, carry on. If not, just concede using the mio box.