How to Route Hubstation with WRT54G w/ Tomato

[lwkoh]

Just got a hubstation and had been trying to share its 1mbps internet with 3 pc. Very light use. At first my wrt54g is flashed with ddwrt which works great previously as a repeater. But it just cannot seem to connect to the net thru the ethernet port in the hubstation. I can access the ddwrt interface. I google quite a bit, tried many settings but cannot work. If I connect the notebook directly to the hubstation ethernet port, I can get net access.

Then I flash it with tomato and reset to factory default settings.
Still cannot have net access though can access the tomato interface.

Can kind souls here advise how to setup the tomato or point me to a site that does that?

TIA

[liangtam]

restart the hubstn after u hook it to the router

[lwkoh]

It works. Million thanks.
2 days of trouble shooting and googling boils down to off/on hubstation.
I did off/on router but it just did not occur to me to do it on the hubstation.
Thanks again.

[liangtam]

It works. Million thanks.
2 days of trouble shooting and googling boils down to off/on hubstation.
I did off/on router but it just did not occur to me to do it on the hubstation.
Thanks again.

..........

[Kiwi8]

It works. Million thanks.
2 days of trouble shooting and googling boils down to off/on hubstation.
I did off/on router but it just did not occur to me to do it on the hubstation.
Thanks again.

LOL. At least u will gain a valuable experience not to repeat it next time. :s13: