View Single Post
Old 13-02-2020, 10:22 PM   #1
Junior Member
Join Date: Feb 2020
Posts: 11
Exclamation Denon AVR-X2400H receiver Protect Mode issue

My Denon receiver (AVR-X2400H) goes into protect mode on startup. I've been using it since Oct-2018 It's hooked up (3.1) to a couple of Paradigm mini Monitor Series 7 bookshelves (8 ohm), Paradigm Series 7 center(8 ohm) and an Emotiva BassX S10 Sub.

It actually went into protect mode 3-4 times last month (always on startup), however, it turned back on after I unplugged and plugged back the speaker cables from the back of the receiver.

A couple days go it went into protect mode when I turned it on and it has stayed that way ever since. I tired to go into protection history mode but it goes into protect mode after 6 seconds of startup. Also tried resetting/initializing the microprocessor, nothing happens.
Also checked all speaker cables for loose wire threads/crossovers etc.

I don't think it's a thermal protect issue. Did a bit of googling and it seems like the amp circuit has tripped.

Do you guys know what could have caused it to go into protect mode?
If I need to get it looked at or repaired, any suggestions where I could go? (preferably near Tampines)
longcock_67 is offline   Reply With Quote