Devil's Canyon Delidding

[Kairos]

Dear All,

Do you know any reputable person or shop that provides the above service?

For my guide, what's the cost and the servicing time?

Thanks.

 

[sglords]

can find uncle spyboy48 in blue forum
he stay in pasir ris though

http://forums.vr-zone.com/hardware-depot/2900968-delidded-4770k-naked-run.html

 

[royfrosty]

You can either look for spyboy or me loh.

I located at central amk though. But i left limited amount of CLP thermal paste left.

 

[ragnarok95]

You can either look for spyboy or me loh.

I located at central amk though. But i left limited amount of CLP thermal paste left.

AMK!!!!!!!!!!!!

I buy new cpu i will find u :

 

[allhomme]

I can lend you my bench vice, wooden block and hammer.

Just curious which DC you getting?

Sent from LGE LG-D838 using GAGT

 

[Kairos]

I can lend you my bench vice, wooden block and hammer.

Just curious which DC you getting?

Sorry for late reply.

Thanks for the offer. But already sent my cpu to royfrosty.

i7-4790K.

 

[escksu]

I can lend you my bench vice, wooden block and hammer.

Just curious which DC you getting?

Sent from LGE LG-D838 using GAGT

Actually don't need hammer lar. Just need a thin blade. 5min job only.

 

[royfrosty]

I prefer the blade. Vice method can work also, but equal risk.

Die can be easily cracked if impact of the hammer and waste wood block is too hard.

I mean, personal preference, but I go with the blade instead as I have more "control" over the vice and hammer method.

 

[predprey]

Vice only delid
This is what I prefer... if only i saw this before i went with the blade and the hammer+vice method....haiz....

 

[allhomme]

The glue is not so strong. Actually I more scared of kena the pcb trace when using razor.

Then again I have not delided many cpus to say so. I only do on my old 4770k and 4790k.

2 out of 2 so 100% success rate. Hahahahaha

Sent from INO SCOUT 2 using GAGT

 

[escksu]

The glue is not so strong. Actually I more scared of kena the pcb trace when using razor.

Then again I have not delided many cpus to say so. I only do on my old 4770k and 4790k.

2 out of 2 so 100% success rate. Hahahahaha

Sent from INO SCOUT 2 using GAGT

Wont lar you just slide the blade in parallel to the circuit board.

Btw, the trick is to use a thin blade (not those fat thick ones). Then it can slide in easily. I delid my 4790K in 5min using the think blade (those for the paper cutter one).

Avoid razor blade because you can cut yourself. HAswell is harder to delid due to the caps. You can slice off the caps if you are not careful.

Hopefully, skylake do not have such caps.

 

[allhomme]

I think I'll stick to the hammer and vice method.... I scared scared

Sent from INO SCOUT 2 using GAGT