Electrician advice needed

ang_moh

Member
Joined
Sep 12, 2009
Messages
146
Reaction score
3
Hi,
my son is working on a wind tunnel project. For that I had bought a 12” inch used fan off Carousell. It was working fine, I removed the covers etc. to be able to attach to a card box and prior to fixing it I did run a test and all was good. I then attached it to the box with doc kinda tape, I pressed quite a bit to make it as flush as possible. Once we pretty much assembled all the parts and wanted to do a dry run the fan was dead. I can’t see any loose cables which I may have caused during installation and I don’t understand what might be broken. I have unfortunately have no device to measure if any power is getting through. I have moved the timer outside as it was too high (white thingy in right hand side). In the middle is the alles knob and Acts as in/off. On left side is the move button for the grill to rotate. In one of the photos I made a red circle, there the red cable going to the timer is a bit loose, it just moves inside but can’t pull out. Any tips are appreciated.







 
Important Forum Advisory Note
This forum is moderated by volunteer moderators who will react only to members' feedback on posts. Moderators are not employees or representatives of HWZ Forums. Forum members and moderators are responsible for their own posts. Please refer to our Community Guidelines and Standards and Terms and Conditions for more information.
Top