Can't connect MG3620 printer wirelessly

[Greent]

Anyone use this printer ?

Tried the hold wifi button but on/off didn't blink

 

[86technie]

According to the manual, it can't directly link the printer to the device.
You need to link it to a router, actual steps are in the manual.

For PC, you need to use the driver installation package.
It will configure as well as search for the printer on the network.
Actual steps I need sometime to recall how to do it
cuz lately I also changed to a similar type of printer.

Now it is working fine, every device just connect VIA wireless.

 

[Greent]

Hi, I have set up the Pixma MG3620 but I cannot set up the wireless printing.

The power light and the wifi light is on which mean is connected
I followed the directions but holding down the wireless button to get the power button blinking does not work. I have held it down multiple times, each time for over 15 seconds.

Direct USB can print but not wireless.

The apps also cannot detect the printer in my wifi list.

 

[yusoffb01]

call their tech support. nobody uses that printer

 

[86technie]

Hi, I have set up the Pixma MG3620 but I cannot set up the wireless printing.

The power light and the wifi light is on which mean is connected
I followed the directions but holding down the wireless button to get the power button blinking does not work. I have held it down multiple times, each time for over 15 seconds.

Direct USB can print but not wireless.

The apps also cannot detect the printer in my wifi list.

Call Canon seek advice since under the Network utility if cannot detect.
Maybe either the printer at fault or certain setting needed to be done.

 

[Greent]

Thank man.

They call me to do a factory reset and if any issue, call again.

Apparently, i found someone from this forum also post the similar issue around June while searching for solution and even US canon users also got this issue.