Cleaning underside / contacts of CPU?

CCCustom

High Supremacy Member
Joined
Jul 18, 2012
Messages
37,314
Reaction score
10,805
Thanks for the replies. I think some of you didn't get what I meant - the Arctic Silver did get on the underside, it happened. There was just so much Arctic Silver that pushing the cloth from 1 corner to the other corner gave me a huge ball of the thermal compound when I reached the other corner, that it touched the underside of the chip. And this was only 1 side ... I had to repeat this 4 times for 4 sides of the chip.

I would have taken a picture of my fingers after I was done with it, but they were covered in so much Arctic Silver I didn't want to get any of it on my phone :s8:

Anyways, I am familiar with how to clean the top / IHS side of a CPU and how to apply thermal compound (I'm an MX4 person btw). It's just the underside / contacts part that I've never had to worry about before.
 

kandinsky

Master Member
Joined
Jan 7, 2015
Messages
4,693
Reaction score
10
Wah, the previous owner making CPU sandwich, bua until so gao :s13:

Saw this video, don't know if it's a good method:

 

shiodong

Member
Joined
Nov 7, 2011
Messages
247
Reaction score
0
i'm wondering is it ok to soak the cpu in isoP alcohol for some time before cleaning off the paste? to me, cpu is like waterproofed enough.
 

monikernemo

Supremacy Member
Joined
Oct 23, 2014
Messages
7,268
Reaction score
1
i'm wondering is it ok to soak the cpu in isoP alcohol for some time before cleaning off the paste? to me, cpu is like waterproofed enough.

Very unadvisable I think.

However IMO you can soak electronic products in water but make sure before using it, there is no sign of moisture. Someone left his laptop under rain and managed to savage it.
 

Wongpk

Master Member
Joined
Jan 11, 2015
Messages
2,825
Reaction score
0
Bought a motherboard + CPU 2nd hand, HSF was still on, and I took it out when I got home to find this :

udXhSSg.jpg


When this picture was taken I'd already cleaned off the centre area of the IHS to look at the S-Spec and country of manufacture, but you should still be able to see that the entire IHS and even the latch (top and underside, no I'm not kidding) were coated with a thick layer of Arctic Silver ... it felt as if the previous owner used the entire syringe in a single application :eek:


Appreciate the advice.
you got a very good 3rd generation motherboard too bad the CPU is gone case

image1.jpg
 

Maeda_Toshiie

Supremacy Member
Joined
May 12, 2007
Messages
6,310
Reaction score
3
Very unadvisable I think.

However IMO you can soak electronic products in water but make sure before using it, there is no sign of moisture. Someone left his laptop under rain and managed to savage it.

There is supposed to be a seal between the IHS and the PCB, but it may not be 100% sealed (seal is obviously ineffective or nonexistent for delidded CPUs). The last think you need is to have moisture to seep under the IHS...
 
Important Forum Advisory Note
This forum is moderated by volunteer moderators who will react only to members' feedback on posts. Moderators are not employees or representatives of HWZ Forums. Forum members and moderators are responsible for their own posts. Please refer to our Community Guidelines and Standards and Terms and Conditions for more information.
Top