vhungryy
Member
- Joined
- Oct 18, 2010
- Messages
- 137
- Reaction score
- 0
Story goes like this.. My mobo on Computer-1 spoilt and I got a new mobo + cpu.. Fixed it up and works fine. Few mins later, my GPU started spinning at 100% rate and display stopped working.
Then I used my Computer-2 to test the GPU. Put it back and forth a few times and somehow it works again on my Computer-1.
So here's the problem. When I tried to switch on my Computer-2 the next day, it started beeping non-stop (short beep) and monitor can't detect any signal. CPU fan is spinning, I see the mobo red lights are on. Computer-2 was working well before I test my GPU of Computer-1.
Things I've tried...
Everything I tried gave the same result. Beep non stop and monitor can't detect signal. Below are the specs. Please HELP!!
Update:
Computer-1:
Processor: Intel Core i5-7400 3.0Ghz Quad Core Processor
Mainboard: Gigabyte 270M-D3H LGA1151 M-ATX Mother Board
Graphic Card: Sapphire HD 6950 2GB
Memory: Crucial 8GB DDR4 2133mhz
Power Supply Unit: Seasonic M12II Bronze 620W ATX12V
Computer-2:
Processor: Intel Core i5 2300
Mainboard: BIOSTAR TH67+
Graphic Card: None
Memory: Kingston DDR3-1333MHz 4GB + 4GB = 8GB
Power Supply Unit: Vios 500W ATX-500W
Then I used my Computer-2 to test the GPU. Put it back and forth a few times and somehow it works again on my Computer-1.
So here's the problem. When I tried to switch on my Computer-2 the next day, it started beeping non-stop (short beep) and monitor can't detect any signal. CPU fan is spinning, I see the mobo red lights are on. Computer-2 was working well before I test my GPU of Computer-1.
Things I've tried...
- Unplug everything and put it back again
- Resit the Ram
- Use only 1 Ram at a time at different positions
- Use a working CPU and test on Computer-2
- Remove bios battery and push down the power button 15secs
- Use another working PSU to test
- Remove everything except Hdd, Ram and CPU to test
- Remove everything except Ram and CPU to test
- Use eraser to rub the gold part of the RAM to clean it
- Connect power plug direct to wall socket
Everything I tried gave the same result. Beep non stop and monitor can't detect signal. Below are the specs. Please HELP!!
Update:
- I noticed LED_D1 is lit up but LED_D2 is not (there's a chart on the mobo, it says it's Memory Error)
Computer-1:
Processor: Intel Core i5-7400 3.0Ghz Quad Core Processor
Mainboard: Gigabyte 270M-D3H LGA1151 M-ATX Mother Board
Graphic Card: Sapphire HD 6950 2GB
Memory: Crucial 8GB DDR4 2133mhz
Power Supply Unit: Seasonic M12II Bronze 620W ATX12V
Computer-2:
Processor: Intel Core i5 2300
Mainboard: BIOSTAR TH67+
Graphic Card: None
Memory: Kingston DDR3-1333MHz 4GB + 4GB = 8GB
Power Supply Unit: Vios 500W ATX-500W
Last edited: