EE2073 help

R

RuiQi_91

Junior Member
Joined
Mar 24, 2011
Messages
92
Reaction score
2
Hello forum ,

EE2073 Introduction to Engineering Design and Project

Any EEE seniors care to share what this module is about ? What is the group size of the project work ? Is it more towards software or hardware ? Example for Lab its basically lab every week with 1 report assignment.
Appreciate the insight :)

Regards
RuiQi
 
J

jiunnlong

Junior Member
Joined
Jun 23, 2013
Messages
25
Reaction score
0
Basically this is the project-based module. Usually 2 people is in a group. You will learn LabView and NI-Elvis III at first few weeks. After learning software you will start making a circuit board by following the lab manual given by school. You will need to solder the component on breadboard and PCB board and collect the data for your circuit. For my batch, I was making an audio amplifier. Every week each pairs should submit up a logbook to record what you have learn and what experiment data you obtain.

Hope my answer clarify your doubt.
 
Last edited:
You must log in or register to reply here.
Important Forum Advisory Note
This forum is moderated by volunteer moderators who will react only to members' feedback on posts. Moderators are not employees or representatives of HWZ Forums. Forum members and moderators are responsible for their own posts. Please refer to our Community Guidelines and Standards and Terms and Conditions for more information.
Top