just pressure wash using normal tap waterWhat type of water
some cover the nanoe sensor then spray while some video just spray water
just pressure wash using normal tap waterWhat type of water
i also plan to use it to deep cleaning of the sofa or mattress when neededW
Why need for AC?
Nanoe looks abit rusty or black wonder how they washjust pressure wash using normal tap water
some cover the nanoe sensor then spray while some video just spray water
i nv see them wipe, only spray water while some cover and use clothes to clear the dust onlyNanoe looks abit rusty or black wonder how they wash
U have the link?i nv see them wipe, only spray water while some cover and use clothes to clear the dust only
U have the link?
i should try this someday with ajax
proper or not i not sure, but what i sure is there many aircon tech in many country doing this type of washing, as a laymen, i prefer not to remove in case the blower alignment goes outi thought proper one will take out the roller to wash in the toilet?
but the bag does look useful, probably will buy one soon
i should try this someday with ajax
yeah, my only worry about doing such cleaning is the electronicsproper or not i not sure, but what i sure is there many aircon tech in many country doing this type of washing, as a laymen, i prefer not to remove in case the blower alignment goes out
i did my first wash last yr, i use plastic bag to tape the electronics area, even the blower (near electronics) i also tape it and advoid spraying water near the blower area ( and aim 45cdegree away from the blower)yeah, my only worry about doing such cleaning is the electronics
if take out i may forget / overlook some small pin or screw
if clean on the blower scared spray water on the electronics
currently for fin and blower i use those dettol wipes do best effort
https://s.lazada.sg/s.XNQ95Exact same cleaning method and using same drainage bag. For the cleaning solution, I mixed Mr. Muscle "Mold & Mildew" with water then apply using pump spray and leave it for like 20 mins before thorough brushing.
Have 5 Aircons at home thus more economical to DIY.
Planning to start DIY cleaning my starmex aircon too.
Bought the water jet pump from taobao.
Looking for a good cheap for the cheapest karcher wetdry vacuum.
One qn, I slowly reading up this thread here. You guys mentioned use the vaccum to suck out the jelly. Is it suck out from the end of the discharge pvc pipe at the toilet there? Where the aircon water discharge from?
if you can reach the small flexible pipe, it is not necessary to use vacuum cleaner, a small disposable pipe cleaner will do. those we used to cleaner riffle in the ns days.For me is right bottom corner of ac. Remove the L cover n pull out the flexible pipe by unclipping it. Immediately suck the flexible pipe using wet vacuum hose while hand holding it to seal most gap of both pipe/hose. I hold for around 1min while slowly flexing the flexible pipe to dislodge any jelly.
How hot is your water boss? Those just boiled from electric kettle ? Got photo to see which part of the front coil where you pour? Newbie here. = )Just sharing.
For years, every 5-6 months, I been pouring hot water towards the front coil which goes into the drain pan and down the drain pipe.. melting all the jelly. Never had a dripping issue.
Hmm, how does a short pipe cleaner actually help to clear out the jelly along the drainage pipe?if you can reach the small flexible pipe, it is not necessary to use vacuum cleaner, a small disposable pipe cleaner will do. those we used to cleaner riffle in the ns days.
wet vacuum is needed if we cannot access the flexible pipe. in this case, connect the vacuum at the discharge pipe in the toilet.
the drainage pipe is big, hard to choke. normally the choking point is at or near the drain hole of the drain pan.Hmm, how does a short pipe cleaner actually help to clear out the jelly along the drainage pipe?
Meanwhile, for my case, I have 3 blowers whose drainage pipes all join into one pipe outlet inside the toilet floor trap.
Instead of vacuuming, I now disconnect the 3 flexi pipe at the blowers, stuff two of them and then blow through the third pipe which is at the leaky blower using my breath via a short extension tube for hygiene.