Phanteks Enthoo Evolv pwm hub

[scorpio88]

Hi all,

It has been more than 5 years since my last build up of my DIY pc. Yesterday I bought my Phanteks casing with my Asrock z370 pro 4 mobo and Cyorig H7 Heat sink.

I understand the pwn hub with the cpu cable is to be connected to the mobo's cpu_fan.
But where can I connect my Cyorig H7 fan to?. What is the correct way of connecting them? And how to configure pwn in my mobo?

Please advise.
Thank you.

 

[singupingu]

The 120mm fan on cryorig H7 is 4pin PWM-controlled as well iirc. No difference from your stock cooler, 4pin as well. The fan on the cooler is to be plugged to cpu_fan header as this header is directly controlled by the temperature of the cpu

For the pwn hub, plugged it to any of the cha_fan header

Sent from Finally Unbanned using GAGT

 

[scorpio88]

The 120mm fan on cryorig H7 is 4pin PWM-controlled as well iirc. No difference from your stock cooler, 4pin as well. The fan on the cooler is to be plugged to cpu_fan header as this header is directly controlled by the temperature of the cpu

For the pwn hub, plugged it to any of the cha_fan header

Sent from Finally Unbanned using GAGT

Hi,

the cpu_fan header is at the mobo?

 

[LLCSG12]

Get a 4pin pwn Y splitter.. one end of the Y to H7 and the other end of the Y to the PWN hub cable of Evolve.. and the splitter is plug into the motherboard cpu fan header.

 

[singupingu]

Hi,

the cpu_fan header is at the mobo?

1. CRYORIG fan -> CPU_FAN at top right corner of mobo

2. PWM hub -> CHA_FAN 1, 2, or 3 (CHA_FAN 1&3 at bottom of mobo, CHA_FAN 2 near the CPU socket.)

Sent from Finally Unbanned using GAGT

 

[LLCSG12]

most of the Heatsink fan cable is not long enough to reach the fan hub..

the Case by right should come with a Y splitter but it is not included..

1. CRYORIG fan -> CPU_FAN at top right corner of mobo

2. PWM hub -> CHA_FAN 1, 2, or 3 (CHA_FAN 1&3 at bottom of mobo, CHA_FAN 2 near the CPU socket.)

Sent from Finally Unbanned using GAGT