To all iPhone 6 plus owners

AdrianKhor

Junior Member
Joined
Dec 19, 2011
Messages
34
Reaction score
0
As all this bendgate issue hits the Internet.. I hope any iPhone 6 plus owners here can share their opinions.

So far after getting the iPhone 6 plus.. did you guys encounter any problems? Normal daily usage in pocket? With case?

One thing that question me is all the issue is from Ang moh side.. Hmm Singapore any reported with this issue ?
 
Last edited:

arcturuz

Greater Supremacy Member
Joined
Apr 7, 2001
Messages
99,347
Reaction score
12,633
no
but sometimes will get paranoid and check my ip6+ for any bend
 

jianrong

Senior Member
Joined
Jul 30, 2006
Messages
2,499
Reaction score
75
Me too. When I sit down to tie shoelace. With the phone in front pocket. Sometime I took out before tie shoelace.
 

alpc

Senior Member
Joined
Apr 29, 2000
Messages
2,008
Reaction score
0
Well, I have sat with my 6+ in my back pocket, and also in my front pocket and did not have any issue. But then I was more cautious when I sit to make sure I don't sit on the phone itself - so no chance for it to be forcefully bend; more like your clothes have to flex to accommodate it. The phone does stick out from the pocket in this manner, but so far so good.
 

AdrianKhor

Junior Member
Joined
Dec 19, 2011
Messages
34
Reaction score
0
Thanks to everyone for putting down your experiences. Been driving me crazy lately cos I cared about my phone alot. Hahaha

Really wanted to go thin profile cases like power support.. Etc.. but was afraid to do so. Ended up going with spigen for more protection.
 

arcturuz

Greater Supremacy Member
Joined
Apr 7, 2001
Messages
99,347
Reaction score
12,633
Thanks to everyone for putting down your experiences. Been driving me crazy lately cos I cared about my phone alot. Hahaha

Really wanted to go thin profile cases like power support.. Etc.. but was afraid to do so. Ended up going with spigen for more protection.

i think the chances of bending the phone is higher when trying to remove a psaj case
 

wkweewee

High Supremacy Member
Joined
Sep 25, 2013
Messages
26,900
Reaction score
14
Wakakaka.. been using and stand by this.

DcKoGQ8.jpg
 

fade_white

High Supremacy Member
Joined
Apr 7, 2005
Messages
46,144
Reaction score
5,948
That's a nice tripod. Looks more sturdy than my cheap mic produced five dollar junk. Where u got it from?
 

wkweewee

High Supremacy Member
Joined
Sep 25, 2013
Messages
26,900
Reaction score
14
That's a nice tripod. Looks more sturdy than my cheap mic produced five dollar junk. Where u got it from?

Can hoot from amazon.. jellyfish mount and tripod haha. Yup pretty sturdy despite 6+'s weight.
 

ceecookie

Arch-Supremacy Member
Joined
Dec 26, 2006
Messages
22,610
Reaction score
881
how wols are u? people alr concerned abt bendgate in sept but turned out to be a non issue
 

fabianlau

High Supremacy Member
Joined
May 2, 2008
Messages
35,226
Reaction score
101
No problem if you put your case and if tight Jean and want to sit down , just take out the phone
 

AdrianKhor

Junior Member
Joined
Dec 19, 2011
Messages
34
Reaction score
0
Nice spigen case BTW. Haha yes. I'm trying my best to take care of it. Furthermore, most of my pants are kinda tight fitting beat it short or long type which is a bit problematic.. Hahah need to start shopping for loose pants now.
 

jianrong

Senior Member
Joined
Jul 30, 2006
Messages
2,499
Reaction score
75
Nice spigen case BTW. Haha yes. I'm trying my best to take care of it. Furthermore, most of my pants are kinda tight fitting beat it short or long type which is a bit problematic.. Hahah need to start shopping for loose pants now.

I'm using rock brand 0.8mm clear casing. Is abit soft. Sitting down to wear shoe got to be careful.
 

striker22

Master Member
Joined
Dec 13, 2011
Messages
2,500
Reaction score
7
Still in my UAG case, no rocking or bending. Only issue is the case quite tight, maybe remove will cause bending. haha.
 

inadatan

Member
Joined
Sep 1, 2008
Messages
177
Reaction score
66
My 6 plus got internal crack which distorted the screen. There's not even a scratch or damage done on the surface of the screen.
Went to service center and said this is accidental because of pressure.

How is apple able to justify that this is pressure damage but not internal manufacturing issue since there's no surface damage!!.
Was told to pay $550 for one to one replacement. Extortion price! No repair!!

Is this how Apple treats its customers for such grey issue?
 

Hello_Kitty

High Supremacy Member
Joined
Aug 1, 2000
Messages
30,832
Reaction score
14,898
I used so long never take care with no casing also no issue. Dropped a few times already.

I think all the iPhone 6 issues are over rated.
 
Important Forum Advisory Note
This forum is moderated by volunteer moderators who will react only to members' feedback on posts. Moderators are not employees or representatives of HWZ Forums. Forum members and moderators are responsible for their own posts. Please refer to our Community Guidelines and Standards and Terms and Conditions for more information.
Top