You create problem(s) if off S1 first follow by S2. {Time too short for discharge}
... delay
... M/B is NOT just in stand-by mode and NOT totally shut-down by Casing OFF power button since the PSU need some time to discharge. .. M/B cap(s) inside needs some time to discharge.
... Ba ba ba
{GOOD power supply will filter the noise, etc}
Better method: After casing power button shutdown, OFF S2 to 100% sure no power to computer and then OFF S1 monitor.
==========================================
... delay
... M/B is NOT just in stand-by mode and NOT totally shut-down by Casing OFF power button since the PSU need some time to discharge. .. M/B cap(s) inside needs some time to discharge.
... Ba ba ba
{GOOD power supply will filter the noise, etc}
Better method: After casing power button shutdown, OFF S2 to 100% sure no power to computer and then OFF S1 monitor.
==========================================
currently my cpu connected to one switch "S2"
monitor to "S1"
after i have done with my work. i shutdown my pc. and when i switch off my monitor power from the wall socket instead of my "S2" cpu first. my PC start to boot up again.
instead i should have switch off my "S2" cpu first.
i assuming if there is any change of voltage, it will trigger to switch my PC while "S2" still on.
however, if my com have been switch off and power off for sometime, it wont trigger or auto boot up when i switch on my power. everthing is alright and fine
Last edited: