Just snagged an X10+ for $280. Mapped and cleaned 1 round so far no problem. I like it!
Some questions:
1. When drawing a virtual wall, its very difficult to move the wall line. Is there any workaround for this weird software bug? I googled and found nothing.
2. I have a peculiar problem: I dont want it to struggle up and down trying to clean the sliding door's track between living room and balcony. Quite painful to watch. I cant set a no-clean zone as the minimum width is about 1.5 feet which is too wide. I only need a no-clean zone of 3inches by 1.5meters, so it'll just pass over this track zone to balcony and avoid trying to clean the track. I tried a virtual wall but need to leave a gap for it to pass through, and it tried to clean that gap struggling to and fro the track again. The virtual wall is quite thick too. Any other ideas?
Solved: close sliding door but leave gap to cross, plus lay a narrow rubber sheet over the track during cleaning
Thanks